Tweco 141i Fabricator User Manual
Operating manual, Fabricator, 141i
Table of contents
Document Outline
- SECTION 1: SAFETY INSTRUCTIONS AND WARNINGS
- 1.01 Arc Welding Hazards
- 1.02 General Safety Information for Victor CS Regulator
- 1.03 Principal Safety Standards
- 1.04 Symbol Chart
- 1.05 Precautions De Securite En Soudage A L’arc
- 1.06 Dangers relatifs au soudage à l’arc
- 1.07 Informations Générales de Sécurité
- 1.08 Principales Normes De Securite
- 1.09 Graphique de Symbole
- 1.10 Declaration Of Conformity
- SECTION 2: INTRODUCTION
- SECTION 3: INSTALLATION, OPERATION AND SETUP
- 3.01 Environment
- 3.02 Location
- 3.03 Ventilation
- 3.04 Electricity Supply Voltage
- 3.05 Electromagnetic Compatibility
- 3.06 Victor Flowmeter/ Regulator
- 3.07 Leak Testing the System
- 3.08 When You Finish Using the Flowmeter/ Regulator
- 3.09 Storage of the Flowmeter/ Regulator
- 3.10 Power Source Controls, Indicators and Features
- 3.11 Attaching the Fusion 140A MIG Gun
- 3.12 Inserting Wire into the Wire Feed Mechanism
- 3.13 Installing 4" (100mm) Diameter Spool
- 3.14 Installing 8" (200mm) Diameter Spool
- 3.15 Feed Roller Pressure Adjustment
- 3.16 Changing the Feed Roll
- 3.17 Wire Reel Brake
- 3.18 Flowmeter/ Regulator Operation
- 3.19 Setup for MIG (GMAW) Welding with Gas Shielded MIG Wire
- 3.20 Setup for MIG (FCAW) Welding with Flux Core (Gasless) Wire
- 3.21 Setup for SPOOL GUN MIG (GMAW) Welding with Gas Shielded MIG Wire
- 3.22 Setup for LIFT TIG (GTAW) Welding
- 3.23 Setup for STICK (SMAW) Welding
- 3.24 Torch Adapter Thumb Screw Replacement
- SECTION 4: BASIC WELDING GUIDE
- SECTION 5:Power Source PROBLEMS AND ROUTINE SERVICE REQUIREMENTS
- SECTION 6: KEY SPARE PARTS
- APPENDIX
- APPENDIX: FABRICATOR 141i CIRCUIT DIAGRAM
- Tweco - LIMITED WARRANTY TERMS
- SECTION 1: SAFETY INSTRUCTIONS AND WARNINGS
- SECTION 4: BASIC WELDING GUIDE