Tweco 300 XT Auto-Cut 400V - Manual (Page 50)

AUTO-CUT 300 XT
�-2 OPERATION Manual 0-5290
4.02 Control Console Features
GCM 1000 XT
GAS CONTROL MANAGEMENT SYSTEM
SHIELD GAS
H20 MIST
RUN
SET
PLASMA SHIELD
A
CUT
OUT
Art # A-11917
Amperage
Selector
Shield
Selector
Run / Set Selector
Plasma Gas
Pressure Gauge
Plasma Gas Pressure
Control Knob
Shield Gas Pressure
Control Knob
Water Mist (Shield) Flow Meter
and Control Knob
Shield Gas
Pressure Gauge
H20 MIST
Run / Set Selector: Use SET position to adjust plasma and shield pressures and flows. Once these are set, switch
to RUN position for operation.
Plasma and Shield Gas Pressure Control Knobs: Adjust plasma and shield gas pressures. Turn knobs to set desired
levels.
Plasma and Shield Gas Pressure Gauges: Display plasma and shield gas pressures.
Shield Selector: Selects shield fluid, gas or H2O Mist (water).
Water Shield Mist (H2O) Flowmeter and Control Knob: Controls flow rate of shield water supply.
Amperage Selector: Continuously adjustable to 300 Amps. Visible here:
A/
Plasma Gas Type Selector (rear panel): Selects proper operating voltage for either Air & O2 or N2 & H35. Also
use N2/H35 setting for F5.