Tweco PCM-120 Machine Torch User Manual
Liquid cooled plasma cutting torch
This manual is related to the following products:
Table of contents
Document Outline
- SECTION 1: GENERAL INFORMATION
- 1.01 Notes, Cautions and Warnings
- 1.02 Important Safety Precautions
- 1.03 Publications
- 1.04 Note, Attention et Avertissement
- 1.05 Precautions De Securite Importantes
- 1.06 Documents De Reference
- 1.07 Declaration of Conformity
- 1.08 Statement of Warranty
- SECTION 2: INTRODUCTION & DESCRIPTION
- 2.01 Scope of Manual
- 2.02 General Description
- 2.03 Specifications & Design Features
- 2.05 Introduction to Plasma
- SECTION 3: INSTALLATION PROCEDURES
- 3.01 Introduction
- 3.02 Site Location
- 3.03 Unpacking
- 3.05 Connecting Torch
- 3.06 Setting Up Machine Torch
- 3.07 Gas Selection
- 3.08 Gas Connections
- SECTION 4: OPERATION
- 4.01 Introduction
- 4.02 Functional Overview
- 4.03 Getting Started
- 4.04 Torch Parts Selection
- 4.05 Cut Quality
- 4.06 Operating the System
- 4.07 Hand Torch Operation
- 4.08 Machine Torch Operation
- 4.09 Recommended Cutting Speeds
- 4.10 Gouging
- SECTION 5: CUSTOMER/OPERATOR SERVICE
- 5.01 Introduction
- 5.02 General Torch Maintenance
- 5.03 Common Operating Faults
- 5.04 Inspection and Replacement Consumable Torch Parts
- 5.05 Troubleshooting Guide
- 5.06 Servicing Hand Torch Components
- 5.07 Servicing Machine Torch Components
- 5.08 Torch And Leads Troubleshooting
- SECTION 6: PARTS LISTS
- 6.01 Introduction
- 6.02 Ordering Information
- 6.03 Replacement Hand Torch Parts
- 6.04 Replacement Machine Torch Parts
- 6.05 Torch Lead Component Replacement Parts (Unshielded Leads Only)
- 6.06 Complete Assembly Replacements
- 6.07 Spare Parts Kits
- 6.08 Options and Accessories
- APPENDIX 1: CUTTING SPEED CHARTS
- APPENDIX 2: SEQUENCE OF OPERATION BLOCK DIAGRAM