Tweco A40-A60 CutMaster - Manual (Page 15)

CUTMASTER A40, A60
Manual 0-5120 INTRODUCTION 2-1
2.01 How To Use This Manual
This Owner’s Manual applies to just specification
or part numbers listed on page i. To ensure safe op-
eration, read the entire manual, including the chapter
on safety instructions and warnings. Throughout
this manual, the words WARNING, CAUTION,
and NOTE may appear. Pay particular attention to
the information provided under these headings.
These special annotations are easily recognized as
follows:
!
WARNING
A WARNING gives information regarding
possible personal injury.
CAUTION
A CAUTION refers to possible equipment
damage.
NOTE
A NOTE offers helpful information concerning
certain operating procedures.
Additional copies of this manual may be purchased by
contacting Victor Thermal Dynamics at the address and
phone number in your area listed in the inside back
cover of this manual. Include the Owner’s Manual
number and equipment identification numbers.
Electronic copies of this manual can also be downloaded
at no charge in Acrobat PDF format by going to the web
site listed below and clicking on the Literature link:
http://www.victorthermaldynamics.com
2.02 Equipment Identification
The unit’s identification number (specification or part
number), model, and serial number usually appear
on a data tag attached to the rear panel. Equipment
which does not have a data tag such as torch and cable
assemblies are identified only by the specification or
part number printed on loosely attached card or the
shipping container. Record these numbers on the
bottom of page 1 for future reference.
2.03 Receipt Of Equipment
When you receive the equipment, check it against the
invoice to make sure it is complete and inspect the
equipment for possible damage due to shipping. If
there is any damage, notify the carrier immediately to
file a claim. Furnish complete information concerning
damage claims or shipping errors to the location in
your area listed in the inside back cover of this manual.
Include all equipment identification numbers as
described above along with a full description of the
parts in error.
Move the equipment to the installation site before
un-crating the unit. Use care to avoid damaging the
equipment when using bars, hammers, etc., to un-crate
the unit.
SECTION 2 SYSTEM:
INTRODUCTION