Triton SJA 200 - Manual (Page 6)

5
GB
INTENDED USE
SuperJaws is a portable work holder which clamps a variety of
workpieces for a multitude of different applications.
UNPACKING YOUR TOOL
BEFORE USE
• Carefully unpack and inspect your tool. Fully familiarise yourself
with all its features and functions
Intended Use / Unpacking Your Tool / Before Use
• Ensure that all parts of the tool are present and in good
condition. If any parts are missing or damaged, have such parts
replaced before attempting to use this tool
SETTING UP
1. With SuperJaws placed upside down on the ground, loosen the
Rear Leg Locking Knob (5) and slide the Rear Leg (6) from its
storage position
• Pivot the Rear Leg just clear of the front face
• Slide it all the way forward then lift and slide it fully into its
housing at the rear, then tighten the knob
2. Raise the Foot Pedal (8) until it ‘clicks’ into position
3. Pivot the Front Legs (9) out as far
as they will go, then turn the Front
Leg Locking Knobs (11) clockwise;
until the rounded section of the
knob tightens onto the leg housing,
as shown
• Several turns may be necessary
on initial set-up, until the clamps
tighten into place. A half turn is all
that is required to release the legs
when folding
4. Turn the SuperJaws upright and recheck all legs are locked
firmly in position
5. Rotate the Moving Jaw Locking Tab (3) to the horizontal
position. SuperJaws is now ready for use
FOLDING
• Folding is the reverse procedure of the steps described above.
Ensure that:
• The Lock / Release Switch (13) is in the ‘unlock’ position
• The Foot Pedal Locking Latch (10) is used to release and fold
the Foot Pedal (8)
• The Moving Jaw Locking Tab (3) is in the ‘vertical’ position to
prevent the jaw from sliding out
• The Rear Leg (6) is engaged fully into its housing, and the Rear
Leg Locking Knob (5) is tightened firmly
•
•
• When in its folded position, the
Rear Leg becomes a carrying
handle, for easy transportation
SJA200_Z1MANPRO2.indd 5 31/03/2014 11:19