Sindoh A611dn - Manual (Page 64)

Using the Printer
3-
20
Caution
- For your convenience, each password character is displayed. Be careful not to expose the wireless AP
password to others.
IP Address Settings
First, you must set the IP address for network print and control. The DHCP server can automatically allocate
or fix the IP. Also, the IP address can be manually set.
Note
- Use the “SINDOH Network Printer Setup” Program to manually set an IP address in IPv6 mode.
Using the Control Panel
1 When the printer is ready, press the 【MENU】 button.
2 Press 【▲】 or 【▼】 until settings appear, and then press the 【OK】 button.
3 Go to Network Settings -> Wireless Network -> Setup Connection.
4 ① IP Automatic Setting: Select DHCP, and then press the 【OK】 button.
② IP Manual Setting: Select Static to type in the IP address, Netmask and Gateway, and then press
the 【OK】 button.
To set the IP address manually, see 「 Method for Manual IP Set-up」 p. 3-17 .
Note
- Use the “SINDOH Network Printer Setup” Program to manually set an IP address in IPv6 mode.
Using the Network Setting Program
1 Connect the USB cable and turn on the device. The printer should not be connected to the device via
USB cable.
2 Run the network setting utility, “SINDOH Network Setup”
3 In the left window, go to [TCP/IP -> Wireless].
4 For IPv4 configuration, select TCP/IPv4; For IPv6, select TCP/IPv6.
5 ① IP Automatic Setting(DHCP): Select [Use Static IP], and then press the 【OK】 button.
② IP Manual Setting: Select [Use DHCP IP] to enter network settings, and then press the 【OK】 button.