Photoflex FV-SLSODKTB StarLite OctoDome nxt: 3 foot kit - Manual (Page 2)

visit photoflex lightingschool .com® for the best free learning resource! For detailed specifications, product tutorials and more, please visit www.photoflex.com®
Rear Cowling
7. Position the rear cowling patch over the corresponding
Velcro ® .
8. Press the cowling in place on the rear of the softbox.
9. The softbox is built and ready to attach to your light
head. Place the dome face down on the floor with the
connector facing up, then securely lock the light onto
the connector. Make sure to always tighten the light
fixtures set screw to the stud on the Litestand.
Securely tighten the tilt bracket on the light to keep it
from falling down.
Inner Baffle
10. The inner baffle has Velcro ® tabs at each corner. These
tabs connect the Velcro ® loops on each inner seam of
the OctoDome.
11. Attach all the Velcro
® tabs.
12. The baffle is now installed.
Face Diffuser
13. The face diffuser is rimmed with Velcro® that attaches
to its counterpart lining the front of the OctoDome.
Note: The face diffuser should attach approximately 1”
2.5cm below the outer edge of the OctoDome to allow
room for adding the grids accessory if needed.
14. Starting at any corner, press the face diffuser in place.
Work your way around the rim of the softbox until the
diffuser is in place.
Warning: Do not leave lights unattended when not in use,
as this can create a hazardous situation.
Figure 9.
Figure 13.
Figure 8. Figure 7.
Figure 11.
Figure 10.
Figure 14.
Figure 12.
Available Accessories
• Softbox Grids
Item# AC-ODGRID XS and S
• Shoemount Flash Hardware
• Wide range of strobe connectors to fit all major brand lights.
Item #AC-B222SM
Customer Support (800) 486-2674
email: [email protected]
Corporate Office (831) 786-1370 • FAX (831) 786-1372
97 Hangar Way, Watsonville, CA 95076
PHOTOFLEX ® WARRANTY
• Warranties only cover manufacturer’s defects and workmanship
• We reserve the right to inspect all merchandise returned (end users
and dealers) for warranty fulfillment.
• All returns must be accompanied by a receipt showing date of
purchase.
• Freight must be paid by the customer or dealer.
• Warranties are valid only from date of Original Purchase.