Kessler MOTION CONTROL: Oracle Controller Full (3.02 SL) - Manual (Page 38)

Note:
You may not see this in the Utility menu unless you have enabled
Simple Mode. (See Simple mode page 30)
*The Kessler Turntable will NOT work in Simple Mode*
Before running your first time lapse on a slider or dolly, perform
the calibration procedure to insure proper function.
1: Once in Slider/TT mode press the MENU button until you
get to the main menu
7. Move the joystick DOWN until SimpleMode PWR is selected
Press the MIDDLE JOYSTICK BUTTON or ENTER to confirm.
Note:
If you need to re-set the power to the default level, press the 1 Button
to select 1:Default Power and then Enter to Save
8. To adjust the Simple mode power level, press the 2 BUTTON
Joystick ^
Utility <
SimpleMode PWR < ^
Current Sense
1:Default Power
2:Simple PWR ADJ
UTILITY - SIMPLE MODE POWER
9. You can adjust the Simple Mode power by moving the joystick
UP/DOWN (Y direction).
Power 40 is the default setting.
If you are moving the camera on a vertical and need more power, slowly
increase this number and test until you get the results you need. For a
totally vertical move with a standard DSLR camera, try adjusting power
to 70 - 80.
If you need your camera to move in the opposite direction of the
default, use a negative number for Simple Mode power. This will
reverse the direction of the motor and subsequently, the direction of the
camera movement.
If your move is going from left to right in Simple Mode with a power
of 40, changing the Simple Mode default power to -40 will reverse the
direction to right from left.
10. Press ENTER to Save or cancel your changes.
11. Press ENTER to Save or press MENU to Cancel
12. After completing the Simple Mode power adjustments and
your test results are favorable, re-run the time lapse calibration
to correct for the new motor power setting.
Quick Tip:
To determine what power to level to enter, set up your rig in the
position you intend to use. In live mode, turn the power dial all the way
down. Move the joystick in the direction you need the camera to move
and slowly turn the power dial up until you get a smooth, non-pulsing
move. Make note of the power reading on the screen and use this num-
ber for your Simple Mode Power level.
Set Simple Mode
Power 40
38