Kessler Crane: Ultra Duty Control Rod Upgrade - Manual

STEP 1
To upgrade your existing t-bar control rods to the
square bar, simply examine your existing configuration,
identify the similar hole pattern and line up the ultra
duty control rods next to your crane.
STEP 2
After removing the bolts from the t-bar, replace that
section with the square bar and reinsert the bolts.
When tightening bolts at pivot points be sure to tighten
until snug then back off until pivot point moves smoothly
with slight resistance. There should be no slop.
Ultra Duty Control Rod
INSTALLATION INSTRUCTIONS