Kessler MOUNTING & GRIP: 100mm Ball Mount for CineDrive Pan & Tilt Head - Manual

Use this 100mm Ball Mount to connect the CineDrive Pan and Tilt Head to
any 100mm or 75mm bowl.
*With its 100mm levelable ball, it can be mounted to any 100mm bowl.
*With its 75mm fixed ring mount, it can be mounted to any 75mm bowl,
however you will not be able to level.
InsTallaTIon
• Locate the mounting base of the
CineDrive Pan and Tilt Head.
• You will see (4) 1/4”-20 countersunk
screws.
• With a 5/32” allen key, remove the (4)
screws from the base of the head.
100mm Ball Mount
for CineDrive Pan & Tilt Head
• once removed, place the ball mount
on the circular base of the head.
• Note, the base should fit inside the
ridge of the ball mount.
• With the ball mount seated properly
against the base, line up the 4 holes
with the holes in the base.
• Finally, screw in the (4) 1/4”-20
countersunk screws that were
removed earlier.