IDX BMS - Manual (Page 69)

User Guide for Battery Management System Ver4.2
Page 69/75 IDX Company, Ltd.
CHAPTER 14. Setting Up BMS-VR
The BMS lets you set up the following hardware:
 BMS-VR: “Termination Voltages” and “Discharge Loads” can be set.
Settings can be entered directly by selecting the applicable ADJ. checkbox in the list on the i-Trax Charger
Menu or BMS-VR Menu screen, or they can also be specified in the Diagnostic screen. The latter method is
explained below.
1. Setting the termination voltage
1) Open the Diagnostic screen from BMS-VR Menu screen.
2) Select “ Discharge Data” in the menu and click “ Load” button.
3) Click Tool(Util), and then select Termination Voltage Setup.
4) The following setup window will open, displaying the current termination voltage
Enter a desired termination voltage within the setting range, and then click OK. The setting will be
recorded in the hardware
2. Setting the discharge load
1) Open the Diagnostic screen from i-Trax Charger Menu or BMS-VR Menu screen.
2) Select “ Discharge Data” in the menu and click “ Load” button.
3) Click Tool(Util), and then select Load Value (Watts) Setup.
3) The following setup window will open, displaying the current discharge load.
Enter a discharge load within the setting range, and then click OK. The setting will be recorded in
the hardware