IDX BMS - Manual (Page 44)

User Guide for Battery Management System Ver4.2
Page 44/75 IDX Company, Ltd.
M WAITING Waiting for BMS recording mode
COMPLETE Charging has been completed
ERROR Error is present
 Battery Model
Model of the battery. “-------” will be shown for unsupported batteries.
 Battery Serial
Serial number of the battery. “--------” will be shown for unsupported batteries.
 ADJ
This checkbox is used to enter a User Battery ID and adjust and specify discharge settings. Selecting this
checkbox will make the corresponding User ID and Term. Volt/Discharge Load fields editable.
Selecting the checkbox again will apply the entered settings to the i-Trax Charger.
 Battery User ID
Optional character string that can be stored in the battery. The USER ID provides a simple means for
identifying each battery. You can set a character string consisting of up to five single-byte alphanumeric.
 Charge Volt
This data is displayed only when the battery is charging. The current charge voltage is indicated
 Charge Current
This data is displayed only when the battery is charging. The current charge current is indicated.
 Discharge Setting: Term. Volt
The termination voltage is indicated. You can enter a desired value with the ADJ checkbox selected. The
value entered here will become the voltage at which discharge will be terminated (setting range: 10.0 to
14.0 V).
 Discharge Setting: Load
The power output is indicated. You can enter a desired value with the ADJ checkbox selected. The value
entered here will become the power output during discharge (setting range: 15 to 45 W).
By double clicking the header part on the list, each item can be sorted and displayed.
You can also access the following function buttons:
 Channel Display Setting (F1)
This button becomes selectable when a Channel field is selected. It is used to set a channel; ID for a
specified channel. Clicking this button will open the following dialog box.
Enter a channel ID consisting of up to seven single digit alphanumeric characters, and click OK. The ID will
be written to the i-Trax Charger on board memory.