E-flite Taylorcraft 450 ARF - Manual (Page 31)

31 E-flite Taylorcraft ARF Assembly Manual
 9. Position the cowling so the hole for the propeller is
centered with the propeller adapter, and so the propeller
will not rub against the cowling. Use low-tack tape to
hold the cowl in position for the following step.
 10. Use a pin drill and 1/16-inch (1.5mm) drill bit
to drill four locations (two each side) for the cowl
mounting screws.
Note: Ensure the painted stripe on the cowl lines up with
the stripe on the fuselage
 11. Use a 3-32-inch (2mm) drill bit to enlarge the holes
in the cowling ONLY.
 12. Apply 2–3 drops of thin CA to each of the holes in
the fuselage to harden the surrounding wood.