E-flite Taylorcraft 450 ARF - Manual (Page 15)

15 E-flite Taylorcraft ARF Assembly Manual
 4. Slide the joiner into the other wing panel. It should
slide in the panel up to or farther than the line drawn in
the previous step. If not, sand the end of the joiner so it
will slide in at least up to the line.
 5. Fit the two panels together. They should fit tight against
each other with no gaps.
 6. Mix around 1/2 oz (15ml) of 30-minute epoxy. Apply
epoxy to the joiner, including any edges that will come in
contact with the wing panel when it is installed.
 7. Apply epoxy inside the opening in the wing as well.