E-flite Brio 10 ARF - Manual (Page 5)

5
Important Information About Motor
Selection
The Brio 10 has two firewall options that are designed
to easily utilize our recommended E-flite ™ Park 480 BL
Outrunner Motor, 1020Kv, the optional Power 10 BL
Outrunner Motor, 1100Kv or our optional Six-Series BL
2700Kv Motor (28mm) with a gearbox. First determine
what power system you will be using, an outrunner or 6-
pole inrunner with a gearbox. You can also use the included
Firewall Stick Mount and easily mount our Six-Series with
a gearbox, or even our Park 480 Outrunner when you use
the included Outrunner Stick Mount. By using the included
outrunner standoffs, mounting a Power 10 Outrunner is also
very easy.
If it's Quique Somenzini's lightweight setup you are looking
for, try using our park 480 Outrunner, 1020 Kv motor
(EFLM1505). For high-speed F3A flying only, we recommend
E-flite’s Power 10 BL Outrunner motor (EFLM4010A). This
setup will weigh about 3 ounces more than the lightweight
alternative.
For a geared alternative with strong vertical power and
speed, try the Six-Series BL 2700Kv Motor (28mm)
(EFLM2005).
Best Recommended Setup
EFLM1505 Park 480 BL Outrunner Motor, 1020Kv
EFLA312B 40-Amp Brushless ESC (V2)
APC11070E Electric Propeller, 11 x 7E
WSD1300 Ultra Plug, Male/Female Set
EFLC3005 Celectra 1–3 Cell Li-Po Charger
Recommended Battery (by E-flite)
THP13203SPL 1320mAh 3-Cell 11.1V Li-Po, 16GA
This is the lightweight setup Quique flies and recommends.
This is the best setup for precision flying, artistic aerobatic
flying, and 3D.
Note: The use of the Thunder Power 11.1V
1320mAh pack with wide open throttle will
discharge the battery at a very high rate.
Proper throttle management is required to
achieve optimum performance and prevent
shortened battery life.