E-flite Brio 10 ARF - Manual (Page 36)

 4. Slide the gearbox into position on the motor
mount. Use a 1/16" (1.5mm) drill to drill a hole
on each side of the gearbox and into the mount.
Stagger the holes so the screws will not interfere
with each other. Secure the gearbox using three
#2 x 8mm screws.
Cowling, ESC and Propeller Installation
Required Parts
• Fuselage
• Cowling
• Prop adapter
• 3mm x 8mm sheet metal screw (4)
• Electric propeller
• Ultra Plug, Male/Female Set (WSD1300)
• Spinner, 1
3 /
4
" (optional) (EFLA270)
• 40-Amp Brushless ESC
Required Tools and Adhesives
• Phillips screwdriver (small)
• Hex wrench: 3/32"
• Nut driver: 7mm
Important Information About Your Brushless ESC
Make sure your ESC brake is programmed
to ‘off’. Also, be sure to use an ESC with the
proper 9V cutoff when using 3-cell Li-Po packs.
We suggest this cutoff to be of the soft variety
to prevent hard motor cutoffs during low level
3D flying.
36