E-flite Brio 10 ARF - Manual (Page 23)

Stabilizer, Elevator & Rudder
Required Parts
• Fuselage w/wing installed
• Stabilizer • Rudder
• Elevator • CA hinge (9)
Required Tools and Adhesives
• Hobby knife • Felt-tipped pen
• Ruler • T-pins
• Thin CA • Hobby knife
 1. Hinge the elevator and stabilizer, using the same
process as described in Aileron Hinging. Use 6
hinges for this process.
 2. Cut the rear of the fuselage using a hobby knife
to allow the stabilizer to be slid into the fuselage.
Caution: Be VERY careful when cutting the rear
of the fuselage with the hobby knife. Always
cut away from yourself and your fingers in case
the knife slips.
23