E-flite Brio 10 ARF - Manual (Page 47)

 6. Use tape to hold the rudder in neutral. Slide a
cable crimp onto the control cable. The cable
then goes through the horn, then back through
the crimp twice. Pull the wire tight, and then use
pliers to secure the crimp. Add a small drop of
thin CA inside the brass crimp to help secure the
wire. Wipe away any excess immediately.
 7. Slide the micro cable adjust connector into
the micro control connector and use a 2mm x
3mm screw to hold it in position. Repeat Step 7,
installing the cable through the cable connector.
47