Banner MICRO-SCREEN Lens Shields - Manual (Page 2)

Banner Engineering Corp., 9714 Tenth Ave. No., Minneapolis, MN 55441 • Phone: (612) 544-3164 • FAX (612) 544-3213 • E-mail: [email protected]
MICRO-SCREEN ® Lens Shields
WARRANTY: Banner Engineering Corporation warrants its products to be free from defects for one year. Banner Engineering Corporation
will repair or replace, free of charge, any product of its manufacture found to be defective at the time it is returned to the factory during the
warranty period. This warranty does not cover damage or liability for the improper application of Banner products. This warranty is in lieu
of any other warranty either expressed or implied.
Maintenance
To prevent loss of excess gain, the shields should be cleaned when they become dirty.
Remove dirt and/or oil from the front face of the shield using a mild detergent or
window cleaner and a soft cloth. Avoid industrial cleaning agents or cleaning agents
containing alcohol, as they may damage the polycarbonate shield material or the
sensor’s status indicators.
Replacement
The shield should be replaced when it becomes pitted or scratched, or excess gain
will be decreased.
To remove, peel the lens shield away from the sensor starting at either end, and
continuing to the opposite end. All or most of the gasket will remain attached to the
sensor; peel the gasket material away. Clean the sensor and install the new lens shield
as described in the instructions on the front of this sheet.