Metrohm 881 Compact IC pro – Anion - Manual (Page 82)

5.5 High pressure pump
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
72 ￭￭￭￭￭￭￭￭
881 Compact IC pro – Anion
￭ Place the valve with the seal faced downwards above the recess
in the holder.
￭ Push the valve components out of the valve housing using the
needle of the tool.
1
3
4
2
Figure 35 Dismantling valve
1 Needle
For pushing the valve components out of
the valve housing. 2 valve
3 Recess
For collecting the valve components. 4 Holder
The components of the valve are collected in the recess of the
holder.
Note
The components of the valve are very small. In order not to lose
them, put the components into a dish.
￭ The inlet valve and the outlet valve consist of the same, just differ-
ently arranged components (see Figure 36, page 73).