Metrohm 881 Compact IC pro – Anion - Manual (Page 21)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
3 Installation
881 Compact IC pro – Anion
￭￭￭￭￭￭￭￭ 11
3 Installation
3.1 About this chapter
The Installation chapter contains:
￭ this overview.
￭ a brief set of instructions for the initial installation of the 881 Compact
IC pro – Anion . At each step you will find cross-references to more
detailed installation instructions for individual components, should you
require such aids.
￭ an installation diagram (see Figure 3, page 15), showing a com-
pletely installed 881 Compact IC pro – Anion.
￭ several chapters with detailed installation instructions for all compo-
nents, including those that are already installed at the time the instru-
ment is delivered.
3.2 Initial installation
Note
A number of the capillaries is already connected at the time the instru-
ment is delivered.
The following work steps must still be carried out:
Installing 881 Compact IC pro – Anion
1 Setting up the instrument
(see Chapter 3.4, page 16).
2 Installations on the rear of the instrument
￭ Place the detector in the instrument and connect it (see manual
of the detector).
￭ Remove transport locking screws (see Chapter 3.6.1, page 19).
￭ Connect the leak sensor (see Chapter 3.6.2, page 20).
￭ Connect the drainage tubings (see Chapter 3.6.3, page 21).