Metrohm 830 IC Interface - Manual (Page 40)

4 Appendix
4 Appendix
4.1 Technical data
Provided that nothing to the contrary is mentioned, the
published data are typical values for the 830 IC Interface
at an ambient temperature of 25°C.
Mains connection
Voltage 100...240 V
Frequency 50...60 Hz
Power consumption 7 W
Fuse 2 × 1 ATH (to be replaced by Metrohm Service
only using the same type)
Additional electronic overload protection
PC interface (RS232)
Connector Dsub connector 9 pin (male)
1 5
9 6
Baud rate 1'200 … 115'200
Data bits 8
Stop bits 1
Handshake Xon/Xoff, none
Parity none, even, odd
FIFO 0 … 16 Bytes
Pin assignment Pin 1,4,6: internally connected
Pin 2: RxD (Received Data)
Pin 3: TxD (Transmitted Data)
Pin 5: GND (Signal Ground)
Pin 7,8: internally connected
830 IC Interface / 8.830.1003 Instructions for Use
34