Metrohm 830 IC Interface - Manual (Page 32)

3 Operation
3 Operation
The operation of 830 IC Interface is made completely via the Metrohm
software «IC Net».
This section describes only the most important points concerning the
operation of the 830 IC Interface. For further details please refer to the
«IC Net» Instructions for Use and to the on-line help in the PC pro-
gram.
3.1 Switch instrument on/off
The 830 IC Interface is switched on and off using mains switch 3 on the
rear of the instrument (see Fig. 3).
After the instrument has been switched on a self-test is running. The
mains pilot lamp 1 flashes twice slowly and remains on to show that the
instrument is ready for use, if an error ocurrs the mains pilot lamp 1
starts flashing fast.
If the mains pilot lamp is flashing fast after the instrument is switched
on an error occured. Switch the instrument off and on, if the error
remains, refer to the Metrohm service.
830 IC Interface / 8.830.1003 Instructions for Use
26