Boss Audio Systems SP-505 - Manual (Page 50)

50
Chapter 5. Deleting or copying a sample
Copying multiple samples
1. Press [SONG] or [PTN] to display the Play screen.
2. Hold down the pad of the sample that you want to
copy, and press [CLIPBOARD].
The sample will be copied to the clipboard, and
[CLIPBOARD] will light.
3. Repeat step 2 for each of the samples you want to copy,
to copy them to the clipboard.
A maximum of 16 samples can be copied to the
clipboard.
* If multiple samples have been copied to the clipboard, pressing
[CLIPBOARD] will play the sample that was copied first.
4. Hold down [CLIPBOARD] and press the copy-
destination pad.
The samples will be copied starting from the pad you
pressed last.
When you press [CLIPBOARD], the sample that will be
copied next will play, allowing you to check the sample.
(Example)
When all samples have been copied, the clipboard will
be empty, and [CLIPBOARD] will go dark.
● If you want to copy to another pad bank, press [PAD
BANK] to switch pad banks. (p. 30)
● If the copy-destination pad contains a sample, you will
be asked “OK to Overwrite?” If you are sure you want to
overwrite (erase) the existing sample, press [F1] (YES). If
you do not want to overwrite it, press [F2] (NO) to cancel
the operation.
● If you hold down [CLIPBOARD] and press [DEL], one
sample that was copied to the clipboard will be erased.
Never turn off the power while the display indicates
“Keep Power On!”
Exchanging samples
You can exchange (swap) samples between two pads to
change the order of the samples.
1. Press [SONG] or [PTN] to display the Play screen.
2. Hold down one of the pads whose sample you want to
exchange, and press [CLIPBOARD].
The sample will be copied to the clipboard, and
[CLIPBOARD] will light.
The copied sample will play when you press
[CLIPBOARD].
3. Hold down [CLIPBOARD], and press the pad of the
other sample you want to exchange.
● If you want to exchange samples with another pad bank,
press [PAD BANK] to switch the pad bank. (p. 30)
The display will ask “OK to Overwrite?”
4. If you are sure you want to exchange the samples, press
[F3] (EXCHANGE).
The samples will be exchanged.
Never turn off the power while the display indicates
“Keep Power On!”
Pad [1]
+
[CLIPBOARD]
→
copy the sample of
pad [1]
Pad [2]
+
[CLIPBOARD]
→
copy the sample of
pad [2]
Pad [3]
+
[CLIPBOARD]
→
copy the sample of
pad [3]
↓
[CLIPBOARD]
+
pad [13]
→
pad [3] sample will
be copied to pad [13]
[CLIPBOARD]
+
pad [12]
→
pad [2] sample will
be copied to pad [12]
[CLIPBOARD]
+
pad [11]
→
pad [1] sample will
be copied to pad [11]