Calculated Industries 44060 - Manual (Page 97)

User's Guide — 95
APPENDIX A — DEFAULT SETTINGS
After a Full Reset/All Clear, your calculator will return to the following
settings:
Setting Imperial Metric
Area Display Standard n/a
Exponent Off Off
(On for Trig Plus III) (On for Trig Plus III)
Desired Riser Height 7-1/2 inch 185 mm
Desired Tread Width 10 inch 250 mm
Fractional Preference Standard Standard
Fractional Resolution 1/16 1/16
(1/64 for Trig Plus III) (1/64 for Trig Plus III)
Jack Rafters Descending Descending
On Center 16 Inch 600 mm
Meter Linear Display 0.000 0.000
Rake Wall Descending Descending
Reg./Irreg. Jack Spacing OC-OC OC-OC
Weight per Volume 1.5 Tons/Yd 3 1775 kg/M 3
Volume Display Standard n/a
Metric Mode
If you work in Metric vs. Imperial measurements, you can set your cal-
culator to “Metric Mode,” where settings or answers are defaulted to
the above metric values. To set the calculator to Metric Mode,
press
the digit [1] key while turning the calculator on. To return to Impe-
rial Mode, repeat this procedure.
ю ю
Note: Removing the battery or a dead battery will cause the calcula-
tor to revert to the default of Imperial Mode.