Calculated Industries 44060 - Manual (Page 24)

22 — CONSTRUCTION MASTER   PRO
[Conv] [Jack] — Irregular Side Jacks
Operates same as [Jack], but displays the rafter values from the
irregular pitched side first.
Rake Wall Function
[Conv] [Rise] — Rake Wall
This function finds the stud sizes in a Rake Wall given computed or
entered values for pitch, rise and/or run. The various sizes will be
displayed via repeated presses of
[Rise]. The sizes can be displayed
in either descending (from longest to shortest) or ascending (from
shortest to the longest) order, depending upon your preference set-
ting (see
Preference Settings on page 96). If a value is entered prior
to pressing [Conv] [Rise], this value will be taken as the Base size
and automatically added to the various rafter lengths.
[Stor] [7] — Store On-Center (o.c.) Spacing
Used to store a value other than the default of 16 inches on center
(e.g., 18
[Inch] [Stor] [7] stores an 18 inch on center) for Rake Wall
stud calculations. Press [Rcl] [7] to review the stored value.