Calculated Industries 44060 - Manual (Page 102)

100 — CONSTRUCTION MASTER   PRO
LT (#4030)
To Set “Fractional Resolution”:
[Conv] [Stor]
(Prefs) (1st press of [Stor]) FRAC 0-1/16 INCH
[+]
(plus sign) FRAC 0-1/32 INCH
[+] FRAC 0-1/64 INCH
[+] FRAC 0-1/2 INCH
[+] FRAC 0-1/4 INCH
[+] FRAC 0-1/8 INCH
To Set Rake Wall Stud Sizes to “Descending” or “Ascending”:
[Stor]
(2nd press of [Stor]) RAKE dESCEnd
[+]
(plus sign) RAKE ASCEnd
To Set “Area” Answer Format:
[Stor]
(3rd press of [Stor]) AREA Std.
[+]
(plus sign) AREA 0. SQ FEET
[+] AREA 0. SQ YD
[+] AREA 0. SQ M
To Set “Volume” Answer Format:
[Stor]
(4th press of [Stor]) VOL Std.
[+]
(plus sign) VOL 0. CU YD
[+] VOL 0. CU FEET
[+] VOL 0. CU M
To Set Fraction Resolution to “Standard” or “Constant”:
[Stor]
(5th press of [Stor]) FRAC Std.
[+]
(plus sign) FRAC ConSt
To Set “Exponential Mode” On or Off:
[Stor]
(6th press of [Stor]) EXP OFF
[+]
(plus sign) EXP On
To Set “Meter” Linear Decimal Format:
[Stor]
(7th press of [Stor]) METR 0.000 M
[+]
(plus sign) METR 0. M
ю ю
Note: Press [On/C] at any time to exit the Preference Mode.