Calculated Industries 44060 - Manual (Page 121)

User's Guide — 119
APPENDIX E — ACCURACY, AUTO SHUT-
OFF, BATTERIES, ERRORS
Accuracy/Errors
Accuracy/Display Capacity — Your calculator has an eleven-digit dis-
play made up of seven digits (normal display) and four fractional digits.
Each calculation is carried out internally to ten digits.
Errors — When an incorrect entry is made, or the answer is beyond
the range of the calculator, it will display the word “
ERROR.” To clear
an error condition you must hit the
[On/C] button once. At this point
you must determine what caused the error and re-key the problem.
Error Codes:
Display Error Type
0-fL0 Overflow (too large)
Error 1 As above, but for exponents (value > 1e74)
Error 2 Divide by 0
Error 3 Dimension error
Error 4 Entry error
Error 5 Type error
Error 6 Trig. error (for example, tan of 1 foot)
Error 7 Does not occur (tape error)
None Attempt to calculate stairs without entering rise or
run
Auto-Range — If an “overflow” is created because of an input and cal-
culation with small units that are out of the standard seven-digit range
of the display, the answer will be automatically expressed in the next
larger units (instead of showing “
ERROR”) — e.g., 10,000,000 mm is
shown as 10,000 m. Also applies to inches, feet and yards.
ю ю
Note: If Exponential Notation is activated through the Preference
Setting, the value will be shown in scientific notation (e.g., 10 million
mm—1.0000
07 mm).