beautypg.com

Calculated Industries 44060 User Manual

Page 120

background image

118 — CONSTRUCTION MASTER

PRO

(Cont’d)

New/Enhanced Function

Description

Preference Settings

−− Dimensional formats for calculated areas and vol-

umes may be set to display in preferred formats

(e.g., sq. feet, cu. yards). Also, Jack rafters and

Rake Wall stud sizes may be set to display in either

ascending or descending order.

(See Preference Set-

tings on page 96.)

Rake Wall

−− Rake Wall is a second function of the [Rise] key.

−− The value stored in the on-center register –

[Stor] [7] – is used for the on-center spacing for

Rake- Wall studs.

−− You may now input a base height from which all

Rake Wall studs will be calculated – e.g.,

[5] [Feet] [Conv] [Rise] will calculate Rake Wall

studs from a base of 5 feet rather than zero.

−− Based on your Preference setting, Rake Walls can

be calculated in descending (default) or ascending

order.

Rafter Cutting Angles

−− You may now calculate Rafter Cutting Angles: Di-

agonal Plumb, Level and Hip/Valley/Jack Plumb,

Level, Cheek.

Stairs

−− Desired value for Riser Height is stored via

[Stor] [Stair]

. (Default value is 7-1/2 inches.)

−− You may now store a desired Tread Width value via

[Stor] [M]

. (Default is 10 inches.) This allows you to

enter only a floor-to-floor rise or only a total run and

still calculate an entire stairway.

Weights

−− Weight per volume is now permanently stored using

[Stor] [8]

.

−− Units available in Pounds (lbs.), Tons, Kilograms

(kg) and Metric Tons.


This manual is related to the following products: