Dimensional measurement unit keys – Calculated Industries 44060 User Manual
Page 15
User's Guide — 13
DIMENSIONAL MEASUREMENT UNIT KEYS
The following keys are used for entering units of measure, with ease
and accuracy:
[Yds] — Yards
Enters or converts to
yards.
[Feet]
Enters or converts to
feet. Also used with the [Inch] and [/] keys for
entering feet-inch values (e.g., 6
[Feet] 9 [Inch] 1 [/] 2). Note: Re-
peated presses after
[Conv] toggle between feet-inches and decimal
feet (e.g., 6
[Feet] 9 [Inch] 1 [/] 2 [Convert] [Feet] = 6.791667 feet;
press
[Feet] again to return to feet-inch-fractions).
[Inch]
Enters or converts to
inches. Also used with the [/] key for entering
fractional inch values (e.g., 9
[Inch] 1 [/] 2). Note: Repeated presses
after
[Conv] toggle between fractional and decimal inches (e.g., 9
[Inch] 1 [/] 2 [Convert] [Inch] = 9.5 inch; press [Inch] again to re-
turn to inch-fractions).
[ / ] — Fraction Bar
Used to enter fractions. Fractions may be entered as proper (1/2,
1/8, 1/16) or improper (3/2, 9/8). If the denominator (bottom) is not
entered, the calculator's fractional resolution setting is automatically
used (e.g., entering 15
[/] [=] or [+] will display 15/16, based on the
default fractional resolution setting of 16ths (default setting for Trig
Plus III is 64ths).
[m] — Meters
Enters or converts to
meters.
[Conv] [5] — Centimeters
Enters or converts to
centimeters.
[mm] — Millimeters
Enters or converts to
millimeters.