Calculated Industries 44060 - Manual (Page 116)

114 — CONSTRUCTION MASTER   PRO
NOTES ON USING THE PRINTER
Auto-Printing Answers
A unique feature of your
Construction Master Pro DT Printer is that it
will automatically print repetitive-solution problems when it is in Printing
Mode (power switch must be set to “Print”). In other words, it will
automatically print all the answers in
[Stair], [Jack], [Rake Wall] and
[Circ] problems upon a single press of the respective key. This saves
keystrokes, or repetitive key pressing.
For example, to automatically print all [Stair] values once the problem
has been “set up” (variables have been entered), simply press the
[Stair] key. All the stair riser/tread variables/inputs and answers will
print upon a single press of the
[Stair] key.
Setting Your Calculator to Auto-Print
You must have your calculator set to “Print,” or switched to Printing
Mode (using the power switch), in order to use auto-printing. The Pref-
erence Setting must also be set to “Print List On.”
(Default is “Off”).
See below:
To Access “Print List On”/Auto-Print Preference Setting:
Press
[Conv] [Stor] to access the Preference Mode. Then press
the
[Stor] key until “Print List Off” is displayed (display reads “LIST
Off”); this is the default setting. To turn Auto-Printing on, press the
[+] key once to advance the display to read “LIST On”. Store this
preference by pressing
[CE/C].