Bendix Commercial Vehicle Systems EB/ES BRAKES SERVICE MANUAL - Manual (Page 51)

50
Figure 71. Shoe Return Spring Installation
Figure 73. Roller and Retainer Installation
Figure 72. Roller Retainer Installation
Shoe Installation
Figure 74. Retainer Installation
T
Installation / Assembly
8. Install shoe return spring. Refer to Figure 71.
NOTE: A lever may be required to assist in hooking return spring.
NOTE: If drums are oversized, see Inspection - Drum Inspection.
9. Assemble roller retainer on ends of roller as shown below. Refer
to Figure 72.
10. Using a lever or large screwdriver, stretch shoe return spring to
allow installation of new roller and retainer assembly on lower shoe
web. Refer to Figure 73.
11. Position roller and retainer in shoe recess as shown in Figure
73. Squeeze loops and swing retainer into position to snap loops
in shoe web holes. Refer to Figure 74. Verify that both retainer
loops are engaged in web holes before proceeding.
12. Repeat process on upper shoe.
13. Install dustshield. Secure with cap screws, Tighten screws to
correct torque, see Specifi cations chart.