Repair / replacement, Lining replacement – Bendix Commercial Vehicle Systems EB/ES BRAKES SERVICE MANUAL User Manual
Page 39
38
3. Clean shoe with solvent if necessary and wire brush shoe
table. Paint with rust inhibitive paint.
4. Install lining blocks.
NOTE: When installing linings or blocks, make sure they are
positioned properly to match rivet or bolt patterns. Refer to Figure
46.
For Riveted Linings: Assemble linings to shoes with rivets
shown below, installing them in sequence shown in Figure 46.
ES-150-6 & 8, ES-165: Bendix Part No. 813250.
EB/ES-150-4L, EB-165: Bendix Part No. 813250.
For Bolted Linings: Using machine screws provided in lining
kit (807933), assemble blocks to shoes in sequence shown in
the illustration for EB-180 brakes. Torque nuts as specifi ed on
installation note provided within the lining kit.
5. Check lining installation by trying to insert a .006" (.15 mm)
feeler gauge between lining and shoe table along edges. It should
not be possible to insert feeler gauge in this manner anywhere
along edge with exception of outside ends beyond last row of
rivets. A larger clearance may exist in these areas.
Figure 46. Lining Rivet (or Bolt) Tightening Sequence
T
Lining Replacement
!
!
Repair / Replacement
WARNING: The long-term effects of non-asbestos fi bers
have not been determined. Therefore, precautions should be
used when handling these materials.
See General Information / Lining Material Warning
NOTE: Reline brakes when inspection indicates replacement is
necessary, see Inspection - Shoe, and Lining Inspection. When
replacing lining only, make sure shoes are in good condition. For
replacement, use only Bendix OEM grade linings or shoe and lining
assemblies.
1. Remove shoe and lining assemblies.
2. Remove lining blocks.
• If blocks are riveted, use a suitable riveting mandrel to push out
rivets.
CAUTION: Drilling out rivets or cutting off upset head with a
chisel may cause rivet or bolt hole elongation.
•If blocks are bolted, remove using suitable tools. Discard
bolts.
•Inspect shoe to be sure it can be reused.
Positioning Lining Blocks
on ES
™
Brake Shoe