Bendix Commercial Vehicle Systems EB/ES BRAKES SERVICE MANUAL - Manual (Page 49)

48
Figure 65. Shoe Return Spring Installation
Shoe And Lining Installation
Figure 64. Roller Retainer Installation
Installation / Assembly
6. For ES-165 5/6/7/8D, L, F, ES-150-4D, ES-150-8D, F & 6D only:
Assemble roller retainer on ends of roller as shown in Figure 64.
7. Using a lever or large screwdriver, stretch shoe return spring to
allow insertion of new pin and roller, (or roller and retainer
assembly) on the lower shoe web. Refer to Figure 65.
NOTE: If drums are oversized, use oversize rollers, see Inspection-
Drum Inspection.
8. For ES-165 5/6/7/8D, L, F, ES-150-4D, ES-150-8D, F & 6D only:
Position assembly in roller recess as shown. Squeeze loops and
swing retainer into position to snap loops into web holes. Refer to
Figure 66. Verify that both retainer loops are engaged in web
holes before proceeding.
9. Repeat process on upper shoe.
NOTE: For all EB Models a roller retainer is not used.
Figure 66. Retainer Installation