Bendix Commercial Vehicle Systems EB/ES BRAKES SERVICE MANUAL - Manual (Page 42)

41
Air Chamber Bracket Installation
EB/ES-150-4L Brake
1. Verify that available air chamber bracket is serviceable. Refer to
Removal/Disassembly - Air Chamber Bracket Removal.
2. Orient bracket to align stabilizing screw with slot in spider and
mounting studs with holes in spider.
3. Position bracket against spider and install lockwashers and
barrel (or standard) nuts on mounting bolts. Refer to Figure 51.
NOTE: Two brake shoe hold-down spring designs are used on the
Model 150 Brakes, see General Information - Parts Nomenclature.
CAUTION: Barrel nuts used in EB-150 brakes must be
retained. Failure to reinstall may cause shoe twist, excessive
noise or improper brake performance.
4. Torque barrel (or standard) nuts to proper torque, see Specifi cations
chart.
5. Install plain washer, lockwasher, and nut on stabilizing screw.
6. Torque nut to proper torque, see Specifi cations chart.
T
T
T
Figure 51. Air Chamber Bracket Mounting Hardware
!
T
T
Installation / Assembly
Spider / Dustshield
Installation
Air Chamber Bracket Installation
1. Verify that available air chamber bracket is serviceable, see
Inspection - Air Chamber Bracket Inspection.
2. On stamped steel spider, orient bracket to align mounting studs
with holes in bracket.
3. Position bracket against spider and install lockwashers and
nuts.
4. Torque stud nuts to proper torque; see Specifi cations chart.
5. On cast spider orient bracket to align bracket holes with tapped
holes in spider.
6. Position bracket against spider and install bolts and
lockwashers.
7. Torque bolts to proper torque; see Specifi cations chart.
8. If air chamber was removed, install chamber and tighten nuts to
correct torque; see Specifi cations chart.