beautypg.com

Rockwell Automation FactoryTalk Historian SE 3.0 H2H Interface Installation and Configuration Guide User Manual

Page 7

background image

Introduction Chapter 1


Rockwell Automation Publication H2H-IN001A-EN-E–July 2012

7

The H2H Interface can be installed on the following architectures:

Item

Description

On the Target Server The Target Server must be a FactoryTalk Historian SE 3.0 server or a

collective of FactoryTalk Historian SE 3.0 servers.

On the Source Server The Source Server may be any of the following:

• A FactoryTalk Historian SE 3.0 server.
• A collective of FactoryTalk Historian SE 3.0 servers.

On a non-legacy
Historian computer

A non-legacy Historian computer is a machine:

• On which neither of the following versions of FactoryTalk

Historian SE is installed:

FactoryTalk Historian SE 2.0
FactoryTalk Historian SE 2.1
FactoryTalk Historian SE 2.2.

• Which is not an Interface node.
• Which is not a client computer.

In all the architectures only a FactoryTalk Historian SE 3.0 server
may function as the Target Server.

NOTE

For information on how to install the FactoryTalk Historian To Historian
Interface on the Source Server or a non-legacy Historian computer, refer

to the FactoryTalk Historian To Historian Interface User Guide. The
document is located in the Common Files\Rockwell\Help directory in
the Program Files (32-bit operating system) or Program Files (x86)

(64-bit operating system) folder.

NOTE

If the Target Server is an OSI PI Server, you need to install the OSI PItoPI
Interface, rather than the Rockwell H2H Interface.

NOTE

For detailed information on the supported configurations of the Source

and Target Servers, refer to the FactoryTalk Historian To Historian
Interface Release Notes
.