Rockwell Automation FactoryTalk Historian SE 3.0 H2H Interface Installation and Configuration Guide - Manual (Page 15)

Installing FactoryTalk Historian To Historian Interface Chapter 3
Rockwell Automation Publication H2H-IN001A-EN-E–July 2012 15
You may be prompted to restart your computer to complete
the installation. If you do not choose to restart your computer
at this time, be sure to restart it at the completion of the
required installation steps for FactoryTalk Historian To
Historian Interface.
To install FactoryTalk Historian To Historian Interface:
1. Double-click setup.exe. The installation wizard appears.
2. On the main page of the installation wizard, click
Install
FactoryTalk Historian To Historian Interface > Install
FactoryTalk Historian To Historian Interface.
The installation wizard appears.
If there are any software prerequisites missing from the
computer, they are listed in red at the bottom of the
installation wizard Welcome page. Click Cancel and Finish
to exit the wizard, install the prerequisites, and start the
installation wizard again.
3. On the Welcome... page, click Next.
4. On the License Agreement page, read and accept the terms of
the license agreement, selecting the I accept... option.
Click Next.
5. On the Review Component Installation page, review the list
of the components that are already installed and those that will
be installed during the installation process.
Click Next.
6. On the Destination Drive page, select the drive on which you
want to install the product.
If the space available on the drive is not sufficient for the
installation, a warning message will appear below the
Installation drive list. In such a case, select another drive or
increase the available space on the drive you have originally
selected.
Install FactoryTalk
Historian To Historian
Interface