Rockwell Automation SA3100 Diag,Troublesht,Startup,Guide User Manual
Rockwell Automation Equipment
Table of contents
Document Outline
- S-3059-1 Distributed Power System SA3100 Diagnostics, Troubleshooting, and Start-Up Guidelines Instruction Manual
- Important User Information
- Contents
- List of Figures
- List of Tables
- Chapter 1 Introduction
- Chapter 2 Diagnostics and Troubleshooting
- Chapter 3 PMI Regulator Operating Modes
- Chapter 4 Installation and Start-Up Guidelines
- 4.1 Using the AutoMax Programming Executive to Access the Rack
- 4.2 Environmental Requirements
- 4.3 Installing the Motor
- 4.4 Installing the Drive
- 4.5 Wiring the Drive
- 4.6 Basic Drive Interconnections
- 4.7 Drive Inspection and Start-up Guidelines
- 4.7.1 What To Do After Unexpected Test Results
- 4.7.2 Recommended Test Equipment
- 4.7.3 Physically Inspecting the Drive
- 4.7.4 Physically Inspecting the Motor
- 4.7.5 Checking the Installation with Power Off
- 4.7.6 Testing AC Input Power Modules with AC Power On
- 4.7.7 Testing DC Bus Supplies and DC Input Power Modules
- 4.7.8 I/O Verification
- 4.7.9 Performing Uncoupled Motor Tests (Vector)
- 4.7.10 Running Dynamic Motor Tests
- 4.7.11 Updated Drawings and Software Listings (Vector)
- Appendix A Drive Fault Register
- Appendix B Drive Warning Register
- Appendix C Interlock Register
- Appendix D Diagnostic Fault Code Register
- Appendix E Summary of UDC Module Drive Fault Indicators
- Appendix F PMI Regulator LED Summary
- Appendix G Status of Data in the AutoMax Rack After a STOP_ALL Command or STOP_ALL Fault
- Appendix H AutoMax Programming Executive Access Levels
- Appendix I Terminal Block Locations and Test Points
- Appendix J PMI Regulator Test Points
- Index