Rockwell Automation SA3100 Diag,Troublesht,Startup,Guide User Manual

Rockwell Automation Equipment

Text mode
Original mode

Instruction Manual

Distributed Power System
SA3100 Diagnostics, Troubleshooting,
and Start-Up Guidelines

S-3059-1

Table of contents

Document Outline

S-3059-1 Distributed Power System SA3100 Diagnostics, Troubleshooting, and Start-Up Guidelines Instruction Manual
Important User Information
Contents
List of Figures
List of Tables
Chapter 1 Introduction
- 1.1 Related Publications
- 1.2 Typographical Conventions
Chapter 2 Diagnostics and Troubleshooting
- 2.1 Definition of Terms Used in Diagnostics and Troubleshooting
- 2.2 Power-up Diagnostics in the UDC Module and PMI Regulator
- 2.3 Interlock Tests
- 2.4 Run-time Diagnostics
- 2.5 Internal DC Bus Diagnostics
  - 2.5.1 DC Bus Monitoring During Bridge Test Mode
  - 2.5.2 DC Bus Monitoring During Torque Minor Loop Mode
Chapter 3 PMI Regulator Operating Modes
- 3.1 Idle Mode
- 3.2 Bridge Test Mode
- 3.3 PMI Tuning Mode (Automatic Gain Calculation)
- 3.4 Run Mode
Chapter 4 Installation and Start-Up Guidelines
- 4.1 Using the AutoMax Programming Executive to Access the Rack
- 4.2 Environmental Requirements
- 4.3 Installing the Motor
- 4.4 Installing the Drive
  - 4.4.1 Enclosed Drives
  - 4.4.2 Open Chassis Drives
- 4.5 Wiring the Drive
- 4.6 Basic Drive Interconnections
- 4.7 Drive Inspection and Start-up Guidelines
Appendix A Drive Fault Register
Appendix B Drive Warning Register
Appendix C Interlock Register
Appendix D Diagnostic Fault Code Register
Appendix E Summary of UDC Module Drive Fault Indicators
Appendix F PMI Regulator LED Summary
Appendix G Status of Data in the AutoMax Rack After a STOP_ALL Command or STOP_ALL Fault
Appendix H AutoMax Programming Executive Access Levels
Appendix I Terminal Block Locations and Test Points
Appendix J PMI Regulator Test Points
Index