Rockwell Automation RSView32 Runtime Users Guide - Manual (Page 46)

RSView32 commands

A–15
ComStatusOn ComStatusOn
Starts logging of communication errors if RSView32 is set up to do so.
To log communication errors, ensure the Communications category is
selected in the Activity Log Setup editor.
To have error logging automatically start when a project starts, open
the Startup editor and click the Communication Status check box.
DatabaseSync
DatabaseSync
Makes RSView32 convert the tag database into binary format the next
time the project opens. Use this command if you change the tag
database that a project uses (using the Project Paths dialog box), after
changing a node’s data source, or after changing a direct driver’s device
type.
To synchronize the tag database:
1. On the command line type DatabaseSync, and then press Enter.
2. Close the project.
3. Open the project. The database will be synchronized as the project
opens.