Rockwell Automation RSView32 Runtime Users Guide - Manual (Page 27)

Running a project

2–11
Changing data logging paths
You can change the data logging paths at runtime. You can change the
primary and secondary paths for dBASE
® IV data log models, and the
backup path for ODBC data log models. You cannot change the
ODBC database using RSView32 Runtime. After you change the
logging path you must stop and restart data logging for the changes to
take effect.
To edit the logging paths:
1. In the Project Manager, open the Data Log folder.
2. Open the Data Log Path editor.
3. Specify paths as described in “Specifying Logging Paths” in
Chapter 7, Configuring data logging, in the RSView32 User’s Guide.
You can also change logging paths at runtime using the DataLogPath
command. For details about the DataLogPath command, see
Appendix A, RSView32 commands, or see Help.
Stopping a project
To stop a project, do one of the following:
in the Project Manager, click the Stop Project button
on the command line, type ProjectStop