Prepare the computer, Before you begin, What you need – Rockwell Automation 1769-L3xx CompactLogix System Quick Start User Manual
Page 27: Chapter 2, Before you begin what you need, Chapter
27
Publication IASIMP-QS001C-EN-P - October 2009
27
Chapter
2
Prepare the Computer
In this chapter, you configure network communication on your computer and install the
necessary programming and configuration software.
Before You Begin
•
Verify that your computer meets the software’s system requirements for your edition of RSLogix 5000
programming software.
•
If using a ControlNet network (option 2), install a 1784-PCIC or 1784-PCICS ControlNet
communication card on the computer.
What You Need
•
RSLinx Classic software, version 2.54 or later (packaged with RSLogix 5000 programming software).
•
RSLogix 5000 programming software (see the
for version and edition information)
•
RSNetWorx for ControlNet software for the ControlNet network
•
RSNetWorx for DeviceNet software for the DeviceNet network
•
ControlFlash software (packaged with RSLogix5000 programming software)
•
BOOTP/DHCP server utility (packaged with RSLogix 5000 programming software).
•
A Network Interface Card (NIC) and its associated Windows driver installed (the NIC and driver are
standard on most computers).
•
An Ethernet Address (MAC) for each device. You recorded these addresses in the
on the back cover.
•
A planned IP Address for each device. If you are using an isolated network, determine a numbering
convention for your IP addresses. Record these addresses on the
inside the back
cover.