Rockwell Automation 1769-L3xx CompactLogix System Quick Start - Manual (Page 184)

184 Publication IASIMP-QS001C-EN-P - October 2009
Chapter 13 Create a PowerFlex 40 Application
5. At the O.Start tag, enter 1.
The drive begins to run and the display will
register the drive’s speed until it reaches 55.5
Hz.
6. After the drive has reached 55.5 Hz,
enter 0 at the O.Start tag.
7. At the O.Stop tag, enter 1.
The drive begins to slow until reaching 0.0 Hz.
8. When the drive reaches 0.0 Hz, enter 0 at the
O.Stop tag.
9. Select Go Offline.
By starting and stopping the drive, you verified that:
• the controller is correctly communicating with the drive.
•
the drive can receive simple commands.
If you are using EtherNet/IP or ControlNet, you are done configuring the PowerFlex 40
drive and you can continue with the next chapter; or see
page 187 for more information.
WARNING
If there is a motor attached to your drive, completing the next
step will cause it to turn.