Rockwell Automation TL-Series Servo Motor - Manual (Page 5)

TL-Series Servo Motor Installation Instructions 5
Publication TL-IN001C-EN-P — March 2005
Before You Install the Motor
1. Remove the motor carefully from its shipping container.
2. Visually inspect the motor for any damage.
3. Examine the motor frame, front output shaft, and mounting pilot for any
defects.
4. Notify the carrier of any shipping damage immediately.
Motor Installation and Maintenance Guidelines
The following sections provide general installation and maintenance information.
The information should assist you to correctly install and to provide maintenance
that will prolong the lifetime of your TL servo motor.
!
ATTENTION
Do not attempt to open and modify the motor. Modifications
that can be performed in the field are described in this manual,
other changes should not be attempted.
Only a qualified Allen-Bradley employee can service this type
of motor.
Failure to observe these safety procedures could result in
personal injury, damage to equipment, and void warranty
coverage.
!
ATTENTION
Ensure that cables are installed and restrained to prevent
uneven tension or flexing at the cable connectors.
Excessive and uneven force at the cable connectors may result
in damage to the connector housings and contacts as the cable
flexes.
Failure to observe these safety procedures could result in
damage to the motor and its components.