Rockwell Automation TL-Series Servo Motor - Manual (Page 21)

TL-Series Servo Motor Installation Instructions 21
Publication TL-IN001C-EN-P — March 2005
Accessories
Factory available accessories for the TL motors are described below.
Motor Cables
Factory manufactured feedback, brake, and power cables are available in standard
cable lengths. Transition cables are available to allow connection of a TL-Series
motor to existing N-Series or Y-Series power, feedback, and brake cables. Factory
cables provide proper shield termination which reduces the potential for EMI.
For a complete listing of available cables refer to your drive’s installation manual,
contact your nearest Rockwell Automation sales office, or access the information
from the web sites referenced in Related Documentation on page 23.
Shaft Seal Kits
Catalog numbers and dimensions for TL shaft seals are shown below.
Motor Catalog Number
1
Inside Diameter Outside Diameter Width
mm (in.) mm (in.) mm (in.)
TL-A110,
TL-A120,
TL-A130 TL-SSN-1 8.9 (0.35) 16 (0.71) 3 (0.12)
TL-A220,
TL-A230 TL-SSN-2 14.0 (0.55) 24 (0.95) 5 (0.20)
TL-A2530,
TL-A2540,
TL-A310 TL-SSN-3 19.8 (0.78) 30 (1.18) 5 (0.20)
TL-A410 TL-SSN-4 24.0 (0.95) 40 (1.57) 10 (0.39)
1 Shaft seals require a lubricant to reduce wear. Lubricant is provided with kit.