Rockwell Automation MPS-xxxx Stainless Steel Servo Motor - Manual (Page 11)

MP-Series Stainless Steel Servo Motor with 100 mm to 165 mm Frame Size 11
Publication MP-IN005F-EN-P - January 2014
2. Form a drip loop in the cable (see page 5 ).
3. Carefully align the flat surface on the feedback or the power/brake cable plug (shown in
the diagram) with the flat surface on the motor connector.
4. Hand tighten the collar on the plug to fully seat it on the connector:
•
Threaded DIN (M4) cable plugs require five to six revolutions.
•
SpeedTec DIN (M7) cable plugs require approximately one-quarter of a revolution.
Do not apply excessive force when mating the cable plug with the motor connector. If the plug
and connector do not go together with light hand force, realign the flat surfaces and try again.
TIP A fully-seated threaded plug leaves a small opening, approximately 1…4 mm (0.04…0.16 in.),
between the connector and the plug.
ATTENTION: Align the keyed connectors and hand-tighten the recommended number of turns.
If you cannot tighten the connectors by hand, verify that the keyed connectors are properly aligned. Do not use
tools (for example, pliers and vise-grips) to tighten the connectors.
Feedback Plug Power and Brake Plug
Align flat surfaces with
logo on top. Align flat surfaces with
logo on top.