Rockwell Automation T3411 ICS Regent Monitored Digital Input Modules - Manual (Page 17)

Monitored Digital Input Modules (T3411)
P D - 6 0 3 1 M a r - 0 6
17
Table 2. Slot Key Positions.
Module Upper
Connector
Lower
Connector
T3411 4 7
Configuration
Each monitored input module is configured using the
W
INTERPRET I/O Configuration Editor. In the editor, you will
perform the steps described below to configure the input
module.
1) Set the Module Type:
Position the cursor on the module slot you wish to define.
Choose Set Module Type from the Edit Menu and select
the T3411, 24 Vdc Monitored Digital Input Module from
the list.
2) Edit the Module Definition:
Choose Edit Module Definition from the Edit Menu. A
dialog box will open where you can define the input module
and point definitions.
Figure 11. Monitored Digital Input Module Definition.