Rockwell Automation SA3100 AutoMax Distributed Power System - Manual (Page 13)

Introduction 1-5
Binder J2-3092 (AutoMax Programming Reference) contains the following
instruction manuals:
• J-3675 Enhanced BASIC Language
• J-3676 Control Block Language
• J2-3093 AutoMax Enhanced Ladder Diagram Editor
• J2-3094 AutoMax Enhanced Ladder Language Reference
The AutoMax Enhanced BASIC Language manual (J-3675), AutoMax Enhanced
Ladder Diagram Editor manual (J2-3093), AutoMax Enhanced Ladder Language
Reference manual (J2-3094), and AutoMax Control Block Language manual (J-3676)
are contained in the AutoMax Programming Reference binder (J2-3092). Application
tasks that run on the AutoMax Processor can be created using any of these three
programming languages. UDC tasks can only be created using the Control Block
language (with a subset of BASIC language functions).
1.4 Standard Engineering Documentation
(Instruction Book)
Rockwell Automation provides a set of standard documentation, referred to as an
Instruction Book, for all engineered drive systems. The Instruction Book provides a
record of the equipment supplied.
Multiple sets of the Instruction Book are usually shipped to the customer by Rockwell
within two to six weeks after final equipment shipment. The quantity of books sent and
the recipients are determined by agreement between Rockwell Automation and the
customer.
After drive start-up, drawings and software listings are revised with any changes made
during start-up. Prints of all revised drawings and listings are re-issued to update the
Instruction Book.
The following is a list of the contents of the Instruction Book. The abbreviation used in
Rockwell documentation follows each title. For a more detailed description of the standard
engineering documentation provided with each engineered system, refer to instruction
manual D2-3115, Installing, Operating and Maintaining Engineered Drive Systems.
• Bill of Material (B/M) - A list of parts and instructions to manufacture and assemble
them.
• Dimension Sheet (D/S) - Drawing providing outline dimensions, mounting
information, and other mechanical information about a part or an assembly.
• Wiring Diagram (W/D) - Reference drawing, including schematic diagrams, for
standard assemblies included in a drive system.
• Elementary Diagram (W/E) - Schematic diagram showing electrical connections of
electronic and electrical devices in the drive system.
• Flow Diagram (W/F) - Diagram showing the relationship between the drive sections,
motors, and mechanical regulation schemes in block format. This drawing type may
also show the network and remote I/O arrangement, as well as any other
communication lines, in a single line diagram format.