Rockwell Automation 2300 Family of Drive Systems Hardware - Manual (Page 38)

3-6 Removing and Installing Roll-Out Chassis Units
4. Fasten four screws to attach the lower mounting angles
(see Figure 3.2).
5. For G-frame 2362 units and M or N-code 2364F units, fasten the two
screws to attach the lower brace
6. If the sealing angle has been removed, fasten the two screws to attach the
sealing angle (see Figure 3.2).
7. Install four screws to attach both of the lower reinforcing angles.
8. Fasten two screws to attach the lower wireway cover (shown in Figure
3.2).