Rockwell Automation 2100 CENTERLINE Motor Control Center (MCC) Units with Horizontal Operating Handl - Manual

Installation Instructions
CENTERLINE 2100 Motor Control Center (MCC) Units with
Horizontal Operating Handles
Catalog Number 2100
About This Publication Use these instructions to install CENTERLINE® 2100 MCC units with
horizontal operating handles.
For additional information on the CENTERLINE 2100 Motor Control Center
(MCC), refer to the CENTERLINE 2100 Low Voltage Motor Control Centers
Instruction Manual, publication
2100-IN012 .
To install units with vertical operating handles, refer to the CENTERLINE 2100
Motor Control Center (MCC) Units with Vertical Operating Handles
Installation Instructions, publication
2100-IN014 .
Topic Page
About This Publication 1
Important User Information 2
Before You Begin 3
Recommended Tools 4
Ground the Unit 4
Install the Unit Support Pan 4
Install Swing-out Latch Brackets 6
Install the Unit 7
Install the Door 9
Additional Resources 11
ATTENTION: All covers and doors must be in place before applying power to the
MCC. If units are removed, they must be replaced with the appropriate items
such as units, doors, and unit support pans. If the unit is not replaced, the arc
resistant rating will not apply.